If you need it, we can provide it. Send us your requests and our customer service team will quickly get you an answer.
Request a QuoteHave you ever experienced scrap metal baler failure while trying to work with it? Well, it may be so frustrating when you don’t know what to do to remedy the problem.
In our mandate to provide the needed support for you, we have some troubleshooting tips here that will help you. Meanwhile, a scrap metal baler is a powerful machine that is used to cut and crush various kinds of scraps into shapes such as cuboids, cylinders, and octagons.
Without much adore, let’s look at common problems you may encounter and ways of solving them.
Failure of a motor to start is one of the common problems people face with this machine. What are the possible causes and how can we solve them? Let's look at them one after the other.
SN |
Possible Causes |
Solution |
1 |
There is no power to the baler |
Check the fuses and the main power supply to ensure there is power. |
2. |
The switch is at the OFF position |
Turn the key to AUTO position |
3. |
The voltage is very low |
Kindly check the motor wiring or the motor nameplate to ascertain the fault. |
4. |
Burnt transformer fuse |
Replace the burnt fuse of the transformer |
5. |
Bad safety door switch |
Replace the bad switch with another one |
Some of the common causes of this problem and respective solutions are:
SN |
Possible Causes |
Solution |
1. |
Rotation of the motor in a wrong direction |
Check the motor direction and direct it to rotate in the right direction. |
2. |
Not enough pressure from the hydraulic system |
Supervise the oil level and add oil to it if it is not enough |
3. |
A bad coil of directional valve |
Replace it with a new one |
4. |
There is blockage of hydraulic system |
Check the system and remove the cause of the blockage. |
5. |
Lack of power supply to the coil of directional valve |
Check the terminal block to ensure that the voltage is 120V |
SN |
Possible Cause |
Solution |
1. |
There is a possibility of internal leaking of the hydraulic pump |
Check the test pump. If it needs replacement, kindly replace it. |
Sometimes, you may experience loss of bales when compacted.
SN |
Possible Cause |
Solution |
1. |
There is a possibility of low hydraulic system pressure |
Supervise the oil level. Also, check the primary relief valve setting |
There is how scrap metal balers shake when in operation.
SN |
Possible Cause |
Solution |
1. |
It is likely debris or dirt build up. |
Check the wear pad and remove all the debris. |
There are cases that you need experts to check your machine for you. Besides, you need to purchase a quality machine from a reputable manufacturer like us. We produce the best quality that meets your needs at an affordable price.
Kindly contact us for a business transaction today. Click here to view our products.
By continuing to use the site you agree to our privacy policy Terms and Conditions.